Collision Repair and Frame Straightening in Riverside
A bent frame throws off ride height, tire wear, and steering, and it can hide from the naked eye. We measure the chassis against factory spec on a heavy duty frame rack and pull it back into tolerance before any panels go on.
What this service covers
- Laser and mechanical measuring against factory chassis dimensions
- Multi-point hydraulic pulls for frame rails, cab mounts, and pillars
- Panel and structural member replacement where pulls cannot restore spec
Signs your unit needs this
- Uneven tire wear or the truck pulling to one side after an impact
- Doors, hoods, or cargo boxes that no longer close square
- Visible kinks or ripples in the frame rails
Our process
- 1Damage assessment with measured frame and panel readings
- 2Documented repair plan and parts order
- 3Structural pulls, panel work, and refinishing
- 4Post-repair alignment and ADAS verification
- 5Final quality check and return to service
Ballpark pricing
Collision Repair and Frame Straightening typically runs $1,500 to $50,000 depending on the unit, parts, and severity. Contact us and we will confirm a firm price after a look. See the full pricing page.
Frequently asked questions
Can a bent commercial frame be repaired or does it need replacement?
Most frame damage is repairable on a frame rack when the rails are pulled back within factory tolerance. We replace a rail or cross member only when the metal is torn or stretched past spec, and we document the decision either way.
Do you work with fleet insurance carriers?
Yes. We document damage with measurements and photos and bill directly with major carriers so your Riverside fleet paperwork moves without back and forth.
Ready to get your fleet back on the road?
Tell us about your unit and we will get you a clear plan and a firm price. Serving Riverside and the Inland Empire.