Telematics and GPS Installation in Riverside
Telematics gives you location, diagnostics, and driver data, but only if it is installed cleanly and wired to the right circuits. We install GPS and telematics hardware across a fleet without creating electrical problems.
What this service covers
- GPS tracker and telematics unit installation
- Clean power, ground, and data wiring
- Fleet-wide rollout coordination
Our process
- 1Circuit and system diagnosis
- 2Component test and confirmation
- 3Repair or reprogram
- 4Function verification
Ballpark pricing
Telematics and GPS Installation typically runs $400 to $3,500 depending on the unit, parts, and severity. Contact us and we will confirm a firm price after a look. See the full pricing page.
Frequently asked questions
Can you install telematics across an entire fleet?
Yes. We coordinate a rollout that keeps units working, installs cleanly, and verifies each unit reports before it leaves.
Will a tracker drain the battery?
Properly installed hardware on the correct circuits draws minimal current. We verify draw so trackers do not cause no-starts.
Ready to get your fleet back on the road?
Tell us about your unit and we will get you a clear plan and a firm price. Serving Riverside and the Inland Empire.